4qd PRO-160-HCV Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Контролер 4qd PRO-160-HCV. 4qd PRO-160-HCV 16 сторінок.
Також для 4qd PRO-160-HCV: Інструкція з експлуатації (16 сторінок)
Друкувати сторінку1.
Introduction
The Pro-160 is an advanced digital PWM motor controller for currents up to 200A.
It uses a specialist microprocessor to control a full H-bridge design that does not
require relays for reversing. The display provides key information to the operator,
and can be mounted separately to the controller if required. It has a full range of
features and is very easy to configure if required.
2.
Do's and Don'ts
Warning – the Pro-160 does not have reverse polarity protection.
Connecting the battery wires incorrectly WILL destroy the controller.
Do
Do read the instructions fully
before installing.
Do take care to connect the
battery wires with the correct
polarity
Do fit a motor suppression
capacitor, and ferrite rings.
Do twist the motor wires
together if possible.
Do call 4QD if you are
uncertain about something
3.
Getting Started
First remove the four screws that hold the cover to the end plates and lift off
the cover.
The Pro-160 is supplied with the keymat ribbon cable not connected to its
socket. We recommend only plugging this in once the Pro-160 has been
fixed in position, the control and power connections made, and you are
ready to start operation.
PRO-160 V2.0 10/19
Do not
Do not allow water to enter
the box.
Page 2
www.4qd.co.uk