Dateq Apollo Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний мікшер Dateq Apollo. Dateq Apollo 11 сторінок.

Turntable / Line Channels (3 , 4 and 5)

These three stereo channels each have two inputs (Phono for turntables and Line for equipment like

CD-players and MD-recorders), volume control, 3-way tone control, crossfader routing selector and

pre-fader listening.

Phono / Line

GAIN

Dual Line Channels (6 and 7)

These channels have an input selector for the two identical stereo line inputs (for equipment like CD-

players and MD-recorders), volume control, 3-way tone control, crossfader routing selector and pre-

fader listening.

Line 1 / Line 2

GAIN

Crossfader and Transform

P Controlled

BEATCOMPARE

TEMPO

SYNC

LEDs A and B above the crossfader indicate if the signal is switched to the A-side or the B-side of

the cross-fader with a crossfader routing select switch. This avoids mistakes, because you can see

immediately if there has been a channel selected on both sides.

With the transform ON-switch pushed in (the transform ON-LED lights up), both the A- and the B-side

of the crossfader will not be heard on the master output. Both crossfader-signals will now only be

passed on if the transform-switch is pushed in. In this way short fragments can be made audible in a

very simple way.

Input selector. Normally the Phono input is selected. Pushed

in is Line (CD, MD, tape). LEDs indicate which input is

selected.

Determines the pre-adjustment of the volume for both the

Phono as well as the stereo Line input.

Input selector. Normally the Line 1 (CD, MD, tape) input is

selected. Pushed in is Line 2. LEDs indicate which input is

selected.

Determines the pre-adjustment of the volume for both the Line

1 as well as the Line 2 input.

Normally all channels are mixed directly to the master output

(with the A/ MASTER/ B-switch in the centre position).

However, the channels can also be sent via the A- or B-side

of the crossfader to the master. Channels via the A-side

cannot be heard with the crossfader in the outmost right

position. Channels via the B-side cannot be heard with the

TRAN SFORM

crossfader in the outmost left position. The crossfader curve

can be adjusted with the trimmer.