4qd PRO-160-S Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Контролер 4qd PRO-160-S. 4qd PRO-160-S 16 сторінок.
Також для 4qd PRO-160-S: Інструкція з експлуатації (16 сторінок)

Друкувати сторінку

Thermistor Input

Can be used to connect external thermistors to monitor external temperatures.

Radio Control Input and BEC

The Pro-160 will accept a standard hobbyist radio control servo signal directly

from a receiver. The receiver should be connected to pins B, C, and D. Pin D is

linked to pin A by Lk1, this can be removed if a 4 wire radio connection is

required.

The Pro-160 is pre-programmed to work with the majority of radio receivers.

Profiles 7 and 8 are pre-configured for RC single ended and joystick use. But to

get the best results you may need to use the RC learn function to properly match

the Pro-160 to your radio system.

The RDO port can act as a BEC for currents up to 1A. Pin B of the adjacent BEC

port can be used in parallel to increase this to 2A if required.

PRO-160 V2.0 10/19

B & D - Thermistors 2 and 3 should be 4QD

part number 39-B0.

If the Pro-160 detects thermistor[s] it will show

the approximate temperature readings on the

display.

Page 5