Datexel DAT8024 Посібник з налаштування
Переглянути онлайн або завантажити pdf Посібник з налаштування для Блок управління Datexel DAT8024. Datexel DAT8024 4 сторінки. Modbus tcp voltage and current output
Друкувати сторінкуDATEXEL
Modbus TCP Voltage and Current Output DAT8024.
Set Up the DAT8024.
1. Connect 24 Vdc to O and P.
2. Connect CAT5 crossover cable to PC and
Ethernet RJ45 Port on the DAT8024.
3. Connect a Multimeter to measure Cur-
rent to terminals 1 and 2 or terminals 3
and 4 to measure Voltage.
4. Power up the DAT8024 Modbus TCP
analog output Module.
It is extremely important to use
a Cat 5 Crossover cable unless a
router is used.
To configure the DAT8024.
1. Start your web browser.
2. Type 192.168.1.100 into the address bar.
3. Click enter and the following page
should be seen.
Entering the User-name and Pass-
word.
1. The password is Fact_user.
2. The Password is Fact_pwd.
3. Click Enter, Run, to run the software.
www.datexel.com
Call 561 779 5660 for technical support.
LLC
1 of 4