Cooking Performance Group CPG-F-15C Встановлення та експлуатація Посібник користувача з технічного обслуговування - Сторінка 4
Переглянути онлайн або завантажити pdf Встановлення та експлуатація Посібник користувача з технічного обслуговування для Фритюрниця Cooking Performance Group CPG-F-15C. Cooking Performance Group CPG-F-15C 6 сторінок. Cpg series fryers owner’s manual
BURNERS / THERMOSTAT OPERATION
After the pilot is lit, turn the gas cock dial to "ON" position.
1. Turn the thermostat dial to any temperature setting and observe the burners ignition. It should
ignite within four seconds.
CAUTION: Main burners shall not be "ON" when the vessel is empty. During
testing, fill the vessel with liquid (oil or water) until above the heat transfer tubes.
FLEXIBLE COUPLINGS, CONNECTORS AND CASTERS
If the unit is to be installed with casters, the installation shall be made with a connector that
complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or
Connectors for Moveable Gas Appliances, CAN/CGA-6.16, and a quick-disconnect device that
complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41,
or Quick Disconnect Devices for Use with Gas Fuel CAN1-6.9. A suitable strain relief must be
installed with the flexible connector.
Restraining device may be attached to the back frame/panel of the unit.
All connections must be sealed with a joint compound suitable for LP gas and all connections
must be tested with a soapy water solution before lighting pilots.
PREPARATION FOR USE
New units have a coating of oil on the interior of the vessel. Remove this coating with hot soapy
water, washing soda, or any other grease dissolving liquid. Rinse thoroughly and drain until all
residues are removed. Wipe dry.
Clean the baskets, crumb screen.
PILOT OPERATION
Check and make sure the pilot is lit. If not, refer to previous section for lighting the pilot.
BEFORE TURNING THE BURNERS ON
1. Fill the vessel with liquid shortening or oil up to the "oil level" marking.
2. Block of solid shortening should not be melted by setting it on top of tubes. This will
damage the vessel and scorch fat. Either melt it first on another appliance or cut into small
pieces and pack tightly below, between and above the burner tubes, without leaving any
air spaces around the tubes. Turn the burners "ON" for about 10 seconds and turn "OFF"
for about a minute. Repeat this "ON-OFF" cycle until all the shortening is melted. If
scorching occurs, lower the "ON" time.
3. Do not overfill the vessel.
MAIN BURNER OPERATION
After the vessel is filled with liquid shortening or oil, set the gas cock dial on the combination gas
valve to the "ON" position.
Turn the thermostat to desired temperature setting.
Page | 4