AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-35 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Пилосос для басейну AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-35. AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-35 12 сторінок. Auto self cleaning

Друкувати сторінку

1. Ideal Water Quality

IDEAL WATER QUALITY

SALINITY

6000ppm (6 grams per litre)

6.8 to 7.4 (for fibreglass, vinyl lined and epoxy painted pools)

7.2 TO 7.8 (for other pool finishes)

ALKALINITY

80 to 150ppm

STABILIZER

40 to 60ppm

FREE CHLORINE

1.0 to 3.0ppm

OPERATION

Mode:Timer

Chlorine Output:

Status: OK

[MENU] The [MENU] button is used to enter or exit the MAIN MENU or to

exit the sub-menus.

[ENTER] The [ENTER] button is used to enter a selected menu, confirm

a setting, or to toggle between modes of operation.

[▲]:

The [▲] button is used to navigate menus and modify settings.

[▼]:

The [▼] button is used to navigate menus and modify settings.

In the case of a mains power disruption, the Pristine chlorinator

will retain all user settings indefinitely. The internal clock can maintain the

correct time for approximately two weeks without connection to the mains

power for re-charging. Simply re-enter the time if the unit is disconnected

from the power for extended periods. See page 11 for details.

Page 7

HELPFUL HINTS

When the pool water is tested accurately and all the recommended levels

are met you should be able to set the Chlorine Production Output to 100%.

(Winter time you may only reach 70-80% because the water is cold)

This means the maximum amount of chlorine the chlorinator is rated at is

being produced.

Production levels may decrease over the years as the coating on the

electrode wears. At this stage you may have to run the Pristine Chlorinator

for longer periods to keep the water at the optimum chlorine level.

If the water is cloudy or the chlorine residual tests are low, then the

chlorine being produced is being lost due to high demand, or the Chlorine

Production Output settings may not be set to the maximum position.

To reduce the chlorine demand, check the pH reading and check for low or

high stabilizer reading. If all tests are correct, then shock treatment with an

oxidiser agent is advised.

Super chlorination is not usually necessary if the pool water balance is

maintained at correct levels. Sometimes however, super chlorination can

be useful when there are high bather loads.

If there are a lot of air bubbles passing through the cell housing, it may not

be possible to achieve 100% chlorine production, as the air bubbles can

interfere with water contacting the cell electrode.

Page 16