4x4 TOUGH 18-22543 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари 4x4 TOUGH 18-22543. 4x4 TOUGH 18-22543 12 сторінок. 4wd awning

INSTRUCTIONS – Attaching to vehicle

NOTE: Regularly check that all nuts and bolts securing the awning to the vehicle

are tight and in good order.

There are many different vehicle set ups; your 4x4 TOUGH® Awning has been supplied

with a fitment kit suitable for many installations. However given the innumerable vehicle

set ups it may be necessary to adapt these procedures to suit your individual situation. It

may also be necessary to purchase additional set up components for your situation.

•

Decide which side of vehicle you require the awning to be installed; most common is

the passenger side, but either side can be used.

•

The side awning may either be mounted to either an existing roof tray or to an

existing set of roof racks.

1. Fitment directly to the side supports of a roof

tray. [Fig. 1]

•

Use the pre drilled holes in the short arm of the

L bracket [short arm must be in a true vertical

orientation] as a template to determine the

correct spacing on the roof tray side supports.

•

Mark the 2 hole positions.

•

Repeat the process on a second vertical roof

tray support, making sure the two L bracket

positions will result in the side awning parallel

with the vehicle.

•

Drill all 4 holes, using a 6.5mm drill bit.

•

Using 4 M6 bolts and 4 M6 Nyloc nuts, place the bolts in the channels incorporated

in the aluminium extrusion (2 in the upper channel, 2 in the lower channel) and slide

these along to align with the drilled holes. This is a 2 person operation. The final

position of the M6 bolts must result in a side awning positioning which does not

extend beyond either the front of rear of the vehicle. Partially tighten the M6 Nyloc

nuts.

•

Stand back, review, if all correct; proceed to tighten all 4 M6 nyloc nuts.

FIG. 1