BENDIX R-8 RELAY VALVE Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Блок управління BENDIX R-8 RELAY VALVE. BENDIX R-8 RELAY VALVE 4 сторінки. Relay valve

Друкувати сторінку

13. Place the piston return spring (if so equipped) on the

piston within the cover.

14. Install the seal ring in the groove of the R-8

and join the two valve halves together.

15. Secure the body to the cover using the four 5/16-18 hex

head cap screws. Torque to approximately 80-120 inch

pounds.

INSTALLING

Prior to installing the R-8

™

air lines should be inspected for kinks, cuts, chafing and

deterioration. Repair or replace as necessary.

1. Mount the R-8

relay valve securely.

™

2. Connect all air lines to the proper ports, using the

identification markings of the lines made before valve

was removed.

3. Test all reconnected air line fittings for leakage.

4. Test valve as outlined in "operating and leakage tests"

section.

WARNING! PLEASE READ AND FOLLOW

THESE

INSTRUCTIONS

PERSONAL INJURY OR DEATH:

When working on or around a vehicle, the following

general precautions should be observed at all times.

1. Park the vehicle on a level surface, apply the

parking brakes, and always block the wheels.

Always wear safety glasses.

2. Stop the engine and remove ignition key when

working under or around the vehicle. When

working in the engine compartment, the engine

should be shut off and the ignition key should be

removed. Where circumstances require that the

engine be in operation, EXTREME CAUTION should

be used to prevent personal injury resulting from

contact with moving, rotating, leaking, heated or

electrically charged components.

valve body

™

valve on the vehicle, all connecting

AVOID

BW1569

3. Do not attempt to install, remove, disassemble or

assemble a component until you have read and

thoroughly understand the recommended

procedures. Use only the proper tools and observe

all precautions pertaining to use of those tools.

4. If the work is being performed on the vehicle's air

brake system, or any auxiliary pressurized air

systems, make certain to drain the air pressure from

all reservoirs before beginning ANY work on the

vehicle. If the vehicle is equipped with an AD-IS

air dryer system or a dryer reservoir module, be

sure to drain the purge reservoir.

5. Following

the

recommended procedures, deactivate the electrical

system in a manner that safely removes all

electrical power from the vehicle.

6. Never exceed manufacturer's recommended

pressures.

7. Never connect or disconnect a hose or line

containing pressure; it may whip. Never remove a

component or plug unless you are certain all

system pressure has been depleted.

8. Use only genuine Bendix

components and kits. Replacement hardware,

tubing, hose, fittings, etc. must be of equivalent

size, type and strength as original equipment and

be designed specifically for such applications and

systems.

9. Components with stripped threads or damaged

parts should be replaced rather than repaired. Do

not attempt repairs requiring machining or welding

unless specifically stated and approved by the

vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make

certain all components and systems are restored

to their proper operating condition.

vehicle

manufacturer's

replacement parts,

™