BENDIX TC-7 TRAILER CONTROL BRAKE VALVE Посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для Блок управління BENDIX TC-7 TRAILER CONTROL BRAKE VALVE. BENDIX TC-7 TRAILER CONTROL BRAKE VALVE 4 сторінки. Trailer control brake valve
Друкувати сторінку
INSTALLATION
1. Using the identification made during removal, reconnect
the air lines to the TC-7
for fittings is 10 ft. lbs.
2. Consult the vehicle manual for instructions on remounting
the TC-7
™
valve in or on the steering column. Do not
overtorque the three 1/4-20 mounting screws. (30-60 inch
pounds) (3.39-6.77 kPa)
™
3. Remount the TC-7
follower(5) and secure flat head screw(14). Torque to
30-60 inch pounds. (3.39-6.77 kPa)
NOTE: Handle position cannot be adjusted.
WARNING! PLEASE READ AND FOLLOW
THESE
INSTRUCTIONS
PERSONAL INJURY OR DEATH:
When working on or around a vehicle, the following
general precautions should be observed at all times.
1. Park the vehicle on a level surface, apply the
parking brakes, and always block the wheels.
Always wear safety glasses.
2. Stop the engine and remove ignition key when
working under or around the vehicle. When
working in the engine compartment, the engine
should be shut off and the ignition key should be
removed. Where circumstances require that the
engine be in operation, EXTREME CAUTION should
be used to prevent personal injury resulting from
contact with moving, rotating, leaking, heated or
electrically charged components.
4
™
valve. NOTE: Maximum torque
valve handle(16) on the hex cam
TO
BW1568 © 2004 Bendix Commercial Vehicle Systems LLC. All rights reserved. 3/2004 Printed in U.S.A.
3. Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended
procedures. Use only the proper tools and observe
all precautions pertaining to use of those tools.
4. If the work is being performed on the vehicle's air
brake system, or any auxiliary pressurized air
systems, make certain to drain the air pressure from
all reservoirs before beginning ANY work on the
vehicle. If the vehicle is equipped with an AD-IS
air dryer system or a dryer reservoir module, be
sure to drain the purge reservoir.
5. Following
recommended procedures, deactivate the electrical
system in a manner that safely removes all
electrical power from the vehicle.
AVOID
6. Never exceed manufacturer's recommended
pressures.
7. Never connect or disconnect a hose or line
containing pressure; it may whip. Never remove a
component or plug unless you are certain all
system pressure has been depleted.
8. Use only genuine Bendix
components and kits. Replacement hardware,
tubing, hose, fittings, etc. must be of equivalent
size, type and strength as original equipment and
be designed specifically for such applications and
systems.
9. Components with stripped threads or damaged
parts should be replaced rather than repaired. Do
not attempt repairs requiring machining or welding
unless specifically stated and approved by the
vehicle and component manufacturer.
10. Prior to returning the vehicle to service, make
certain all components and systems are restored
to their proper operating condition.
the
vehicle
manufacturer's
®
replacement parts,
™