Active Grow Walden Посібник з монтажу
Переглянути онлайн або завантажити pdf Посібник з монтажу для Намет Active Grow Walden. Active Grow Walden 3 сторінки. Grow tent
Також для Active Grow Walden: Посібник з монтажу (2 сторінок), Посібник з монтажу (2 сторінок)
Друкувати сторінку
Walden Grow Tent Installation Guide
Important
• Read all product labels and instructions before assembling and installing the tent.
• Installation does not require any tools. Before assembling the tent, confirm that all pieces needed for
installation have been included in the tent packaging.
• Contact Active Grow directly at [email protected] if any damaged or missing parts are discovered
after opening the tent packaging.
• To avoid tearing or ripping the tent do not use excessive force when covering the frame with the tent
fabric. Any damage to the frame or tent fabric during installation as a result of not following the installation
instructions will void the warranty.
• Do not hang equipment >110 lbs on any poles. Do not place equipment >45 lbs on any shelves.
• Do not use abrasive materials or any substance that can damage the tent fabric when cleaning the tent.
Tent may be cleaned using soap and water or other standard hydroponic sanitizers.
Tent Assembly Instructions
E Poles x4
G Poles x1
C Poles x4
D Poles x4
A Poles x4
B Poles x6
F Poles x1
1. Before assembling the tent, confirm that all pieces needed for installation have been included in the tent packaging.
Ex2
x4
Ax2
2. Build the bottom of the tent using Corner Connectors x4, E
Poles x2 and A Poles x2. Make sure tent poles are seated firmly in
Corner Connectors after inserting.
Dx4
4. Add another section of vertical poles using D Poles x4. Make
sure the bearings on C Poles align correctly with the holes on D
Poles and snap into place.
Corner Connectors x8
Shelving Sections x6
Shelving Connectors Lx6 Rx6
E
A
E
Active Grow LLC, (206) 792-9799, 12345 Lake City NE #2137, Seattle, WA 98125
www.activegrowled.com
Shelving & Lateral Roof
Support Clamps x26
Support Clamps x2
Fan/Filter Straps x2
Cx4
A
3. Slide C Poles x4 into existing Corner Connectors. Make sure tent
poles are seated firmly in Corner Connectors after inserting.
x12
Bx6
5. Build Shelving Support Cross Sections x6 using Shelving
Connectors x12 and B Poles x6. Note: All wing nuts on Shelving
Connectors should be facing inside the tent. Slide all Shelving
Support Cross Sections down the vertical poles to desired heights
and tighten securely using each connector's wing nut.
For use with: AG/24TENT/W/3S
Medial Roof
Tent Canvas x1
Spill Tray x1