Benedini TBS Mini Посібник з технічних даних - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з технічних даних для Обладнання для запису Benedini TBS Mini. Benedini TBS Mini 11 сторінок. Digital multifunctional rc-soundunit
Також для Benedini TBS Mini: Посібник (11 сторінок), Посібник (11 сторінок)
Друкувати сторінку
1. Features
The TBS Mini is developed for all kind of RC models, including airplanes, tanks, trucks,
crawlers...
It is an enhanced version of the proven TBS Micro Sound unit.
•
Fully customer programmable. Your own sounds can be loaded!
•
Large sound library of original recordings available. Please check www.benedini.de
•
Sound quality 8 / 11 / 16 / 22KHz
•
Capability to play two sounds simultaneously (engine and one special sound)
•
2 Mbyte of sound memory, enough for 93sec. at 22KHz
•
Internal amplifier with 1.2W if using an 8 Ohm speaker.
•
External high power amplifiers available
(f.e. 2x40W at 2Ohm and 12V supply OR 50W at 8 Ohm and 50V supply)
•
Up to 6 switching outputs.
- Triggerable by sound (eg Muzzle flashing) or independently (universal switching unit)
- Switching
•
Two servo signal outputs (eg For retractable landing gear)
•
Only one proportional channel necessary to control all functions of the unit.
•
The speed signal is taken from the receiver. This allows combination with brushless or
brushed motors.
•
Horizontal plug connections. This allows total electric isolation by heat shrink tube.
•
Very small dimensions and weight
•
USB or RS232 programming cable available (optional)
•
Totally programmable by the free of charge software "TBS Flash":
- You can load your own sounds or any of the Benedini sounds available at
- Firmware update! This means you have always the latest software at you unit.
- FREE OF CHARGE sound libraries available at www.benedini.de
The TBS Mini sound unit can be fully configured by the optional USB programming cable and a
PC. Please see the separate programming manual.
The unit can be controlled by a spare proportional channel which uses an input device to drive it
such as listed below. Eg Most programmable TX's have one 3Pos switch already installed.
You can purchase, or make, a rotary encoder or push button panel, and it is also possible for you
to replace a rarely used Pot input on the TX with another 3Pos switch for sound unit use.
•
12-position encoder (combination of rotary switch and push button)
for Direct Sound Selection
•
3Pos switch for Direct Sound Selection (2 methods)
•
3Pos switch for Indirect Sound Selection
•
Autostart (without any additional proportional channel for control)
The desired control mode can be set by using the USB programming cable with a PC, or
manually on the Sound Unit (without PC).
TBS Mini
- momentary
- or flashing mode adjustable
www.benedini.de
www.benedini.de
Page 2 of 11