GAD BLACKY Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Ді-джейське обладнання GAD BLACKY. GAD BLACKY 7 сторінок. The professional projection shutter for theater, concert, stage and multimedia performance

Друкувати сторінку

2) Adjustment and Assembly

a) Basic Setup

Dip switch factory presets:
This is the standard position mode for a use with a DMX system (channel 001) or with the remote
control. In the appendix of this manual you will find a DMX table with all possible DMX addresses.
Any changes to the DMX address becomes effective only after a full reset of separating the
Blacky from the power supply and plugging it back in.
The factory preset of Switch 10 is the OFF position. This switch serves as a maintenance reference for
the manufacturer and deactivates the device when turned to the ON position.
b) Adjusting the pivoting angle
With switches 11 and 12 you can vary the pivoting angle - see the table:
S1 180° 135° 90° 60°
11
on
on
12
on
off

c) Remote and DMX Connections

DMX-IN: this jack is the input for both the DMX connection and the remote control. This device can only
be operated by either DMX or remote control.
DMX-OUT: an output for extending the DMX chain to other devices. If this is the last device in the chain
then an appropriate terminator should be used.
BLACKY can be used with a DMX 512/2000 system (uplink only) as well as a DMX 512/1990 system
with the appropriate adapter, (XLR 5-pole>XLR-3-pole), without changing the setup.

d) DMX 512/2000 downlink

In order to avoid any interference when using a DMX 512/2000 system with a downlink function,
jumper 1 and 2 inside the device must be changed to Position 2-3.
It is impossible, however, to use the remote control with this jumper position!
off
off
on
off
Switches 1 to 9: DMX-Address: Address 001
Switch 10:
factory maintenance setting:
standard OFF
Switches 11,12: Pivot angle position: 180°
3