AFF GODEATER Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Блок управління AFF GODEATER. AFF GODEATER 2 сторінки. Understanding and caring for your animal godeater eurorack module
Друкувати сторінку
AUDIO I/O
IN: Signal goes in here.
DRY OUT: A buffered 1:1
copy of the input signal,
unaffected
by
all
controls and inputs.
WET OUT: This output gives
you only the distorted signal
at FULL volume - i.e., the
WET VOL control has no
effect on it yet.
MIX OUT: This output is the
mix of clean and dirty
signals.
1. The output level of the
distorting circuit on a 12V
supply is slightly lower than
of the input. This is because
the MIX output with both
CLEAN and WET knobs on
full can be almost 1.5x the
input signal
(tested on a 10V p-p sine
wave).
ENVIRONMENT
Do not dispose of any part of this module in household
waste.
Electronics must be disposed of safely according to the
electronics disposal norms in your country.
This module was constructed using lead-free solder and
observes compliance with the RoHS directive.
All parts of our packaging are designed to use minimal or
no plastic.
Use the box and the velvet bag to keep other things safe.
Subscribe to our newsletter for updates regarding expansion modules and manual updates...
AFA GODEATER EURORACK MANUAL (V2, 2022 ) UPDATED APRIL 10 2022
CV I/O
DRY VOL CV: Controls the
amount of clean volume to
the MIX OUT. When XFADE
is activated, a rising CV will
other
blend from dirty to clean
INPUT
increases distortion. INPUT
LEVEL knob acts as offset.
TONE CV: Sweeps from bass
to treble or vice-versa using
the
TONE
switch. TONE knob must be
set correctly for effective
operation!
2. The INPUT LEVEL, DRY
and WET knobs can be used
as offsets and negative CVs
applied for ducking effects.
CONTACT/QUESTIONS/COMMENTS/FEEDBACK
PAGE 2/2
CV:
Rising
CV
DIRECTION
TECHNICAL SPECIFICATIONS
WET VOL CV: Controls the
amount of dirty volume to
the MIX OUT. When XFADE
is activated, this input is
deactivated.
HPF CV: Rising CV increases
cutoff frequency. HPF knob
acts as offset.
CLIP
D/CLIP
L:
Activate
clipping with increasing CV.
Useful for waveshaping.
TIPS & TRICKS
3. If you don't feel like
distorting things, you can
always use GODEATER as a
clean or coloured VCA using
the DRY VOL CV and WET
VOL CV inputs.
4. The MIX OUT is inverted
compared with the input
signal.
Power Draw:
+12V: 35mA
-12V: 25mA
Size: 14HP
Skiff friendly
EXPANSION HEADER