Active Products PW0501400 Інструкція з експлуатації - Сторінка 16
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мийка високого тиску Active Products PW0501400. Active Products PW0501400 16 сторінок. 1200 everyday pressure washer
Друкувати сторінку
TROUBLESHOOTING
– continued
Symptom
Cause
Garden hose
Loose fittings.
connection leaks.
Missing/worn rubber washer.
Spray wand, or
Spray nozzle not properly attached.
extension, or
nozzle leaks.
Broken o-ring or plastic insert.
Pump is noisy.
Pump is sucking air.
Water leaks from
Loose fittings.
pump (up to 10
Water seals are damaged or worn.
drops per minute
is permissible).
Oil Drip.
Oil seals are damaged or worn.
Motor buzzes
Supply voltage below minimum.
but fails to run.
System has residual pressure.
Voltage loss due to extension cord.
Pressure washer not
used for long periods.
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, VISIT OUR WEBSITE AT
WWW.ACTIVEPRODUCTS.COM OR CALL CUSTOMER SERVICE AT 1-866-924-7626 FOR
ASSISTANCE.
Solution
Tighten fittings.
Insert new washer.
Insert the spray nozzle into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
Call Customer Service.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.
Check that all fittings are tight.
Call Customer Service.
Call Customer Service.
Verify that only the pressure washer is
running on this circuit.
Turn unit "OFF", squeeze trigger on
spray want to release pressure, then
turn unit "ON".
Do not use extension cord with this
unit—plug directly into power outlet.
Call Customer Service.
14