HHO Plus CCPWM60A Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари HHO Plus CCPWM60A. HHO Plus CCPWM60A 10 сторінок. Hho hydrogen on demand dual fuel generator systems
Також для HHO Plus CCPWM60A: Посібник з монтажу (11 сторінок), Посібник з монтажу (12 сторінок), Посібник з монтажу (10 сторінок)
Друкувати сторінку
Amperage
The Maximum Current Panel will appear for you to set the amperage value you wish to work:
Minimum 1 A / Maximum 60A
1. If you press the left button (Edit)
the editing value;
2. Use the left button (UP)again
3. Press the right button (Next)
4. Repeat points 2. And 3. to continue editing. After, i
a. If you make one single click on the
If you make one single click on the right button you will exit configuration pan
b. If you click and hold right button for 3 seconds you will
If you click and hold right button for 3 seconds you will Save your configuration. A message
Savedwill appear.
5. Press right button (Next) to move to
Maximum Voltage
For security reasons (ex: charging the battery)
For security reasons (ex: charging the battery) above 15,5V the CCPWM will not work and a
appear.
will appear for you to set the amperage value you wish to work:
will appear for you to set the amperage value you wish to work:
left button (Edit) you will enter the editing mode. A yellow cursor will appear marking
again to move up the value;
to change the yellow cursor position;
to continue editing. After, in the right button, Exit/Save
move to Maximum Voltage Panel
.
5. Press right button (Next) to move to
CCPWM60A – Installation Manual
you will exit configuration panel (Exit);
The Maximum VoltagePanel will appear
the higher voltage value you wish to work
value you wish to work. The maximum value
allowed is 15,5V.For security reasons (ex: charging the battery
15,5V.For security reasons (ex: charging the battery
with an external power supply), if the voltage in the car is
with an external power supply), if the voltage in the car is
higher than the value selected then the CCPWM60A will stop
working and an alarm will appear.
working and an alarm will appear.
To set this value just proceed in the same way as explained for
To set this value just proceed in the same way as explained for
the setting the amperage.
V the CCPWM will not work and a blue light will
Installation Manual
A yellow cursor will appear marking
Exit/Save will appear:
your configuration. A message
will appear in order for you to set
en the CCPWM60A will stop
move to Minimum Voltage Panel
8
Saved