Gage Bilt GB713 Оригінальна інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Інструменти Gage Bilt GB713. Gage Bilt GB713 20 сторінок.
Також для Gage Bilt GB713: Посібник з монтажу (14 сторінок), Оригінальна інструкція з експлуатації (18 сторінок)
Друкувати сторінку
When the air actuator assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the
valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward
direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool.
Simultaneously, the piston rod assembly, connected to the air piston assembly, is also moving down, forcing hydraulic oil up and into
the front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly. The internal
components of the attached nose assembly are also moving with the piston to start the fastener installation. When the fastener
installation is completed, the air actuator assembly is released. Air pressure is then built up inside of the handle assembly causing
the valve spool assembly to return to its original position and reversing the sequence directing air pressure to the rear of the head
cylinder assembly, causing the piston to move to the forward position.
Air exhaust
Piston Rod Assembly
moves down
Air Piston
moves down
GB713 Installation Tool
PRINCIPLE OF OPERATION
PULL Cycle
Air exhaust
Pressurized Oil
Unpressurized Oil
Images may not reflect actual tool.
Piston Rod Assembly
moves up
Air Piston
moves up
Pressurized Air
Unpressurized Air
7
RETURN Cycle
Air exhaust
7/11 REV 5/22