Gage Bilt GB910 Посібник із швидкого старту - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Інструменти Gage Bilt GB910. Gage Bilt GB910 13 сторінок. Hydraulic powerunit

DESCRIPTION

The GB910 Powerunit is a portable, air operated hydraulic power source designed to operate Gage Bilt hy-

draulic installation equipment. It is also compatible with HUCK® hydraulic installation equipment.

The GB910 Powerunit operates on 90 - 120 psi., using 62 cfm @ 100 psi.

The minimum hose recom-

mended is ½" ID.

Page 9 & 10 shows construction features of the GB910 Powerunit and identifies main components. Hy-

draulic pressure is developed by a two-stage, gear piston hydraulic pump driven by a 1-1/2 hp motor.

Pump output is directed to either the PULL or RETURN pressure ports of the installation equipment by a

four-way directional valve. The directional valve is controlled from the installation equipment by an air trig-

ger.

For the protection of the equipment and operator, an internal relief valve is pre-set at the factory. An exter-

nal relief valve controls the PULL pressure. A pressure switch controls the RETURN pressure and auto-

matically turns off the GB910 Powerunit. When the trigger is released, the installation cycle is finished.

As shipped by the factory, the external relief valve Pull pressure is set at 10,000 psi (68,950 kPa) & Return

pressure at 6,000 psi (41,370 kPa) for GB7624. When attaching GB585A set Pull pressure to 5,400-5,700

psi (37,350-39,300 kPa) & Return pressure 2,200-2,400 psi (15,200-16,500 kPa).

CAUTION:

SEVERE PERSONAL INJURY OR DAMAGE TO THE SYSTEM AND PERIPHERAL

EQUIPMENT MAY OCCUR IF PRESSURES ARE NOT PROPERLY CALIBRATED. CONSULT YOUR

INSTALLATION TOOL MANUAL FOR RECOMMENDED PRESSURES, AND ON PAGE 5 & 6 OF THIS

MANUAL FOR DIRECTIONS.

The reservoir is equipped with two handles to ease the transferring of the GB910 Powerunit to various

sites. The GB910 Powerunit weighs approximately 89 pounds (40.4 Kg) when filled with hydraulic fluid.

Hydraulic quick disconnect couplers are supplied for connecting the tool hoses from the installation equip-

ment.

REV. 10/13