Gage Bilt GB2620PT Оригінальна інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Електроінструмент Gage Bilt GB2620PT. Gage Bilt GB2620PT 20 сторінок. Installation tool
Друкувати сторінку
WARNING:
Any other use is forbidden.
The GB2620PT / GB2620PTA is a hydraulic installation tool designed specifically for the efficient installation of 1/2" diameter lockbolts only.
It weighs 9 lbs. 14 oz. (4.5 kg). It has a 1.437" (36.5mm) fastener setting stroke and a rated pull load of 17,745 lbs. (78.9kN) @ 6,500 psi. (448.2 bar).
The GB2620PT (Electric actuated) installation tool operates on hydraulic pressure developed by the GB940 powerunit set at 7,400 psi.
(510.2 bar) maximum PULL pressure and 3,200 psi. (220.6 bar) maximum RETURN pressure, enabling the tool to pull all the fasteners listed
on the selection chart without adjusting pressures. Powerunit may be set to the pressures only needed to pull your specific fastener
using the pressure gage assy (942280). The tool comes equipped with 2 feet (.61 m) of hydraulic hoses, couplings, electric switch and cord.
The GB2620PTA (Air actuated) installation tool operates on hydraulic pressure developed by the GB910 powerunit set at 7,400 psi.
(510.2 bar) maximum PULL pressure and 3,200 psi. (220.6 bar) maximum RETURN pressure, enabling the tool to pull all the fasteners listed
on the selection chart without adjusting pressures. Powerunit may be set to the pressures only needed to pull your specific fastener
using the pressure gage assy (942280). The tool comes equipped with 2 feet (.61 m) of hydraulic hoses, couplings, air actuator and tube.
ALL GAGE BILT HYDRAULIC INSTALLATION TOOLS ARE COMPATABLE WITH HUCK® POWERUNITS. NOSE ASSEMBLIES ARE
NOT FURNISHED WITH THESE TOOLS AND MUST BE ORDERED SEPARATELY. (See nose assembly selection chart on pg. 14).
WARNING:
Do not operate in an explosive atmosphere.
The GB2620PT / GB2620PTA can be operated between 0ºF - 118ºF (-17.8ºC / 47.8ºC)
GB2620PT / GB2620PTA INTALLATION TOOL
ENVIRONMENTAL USE
Weight
Hyd. pressure req'd
Hyd. Power Source
Hydraulic Oil
Setting stroke
Rated pull load
Noise level
Vibration
DESCRIPTION
SPECIFICATIONS
- 9 lbs. 14 oz. (4.5 kg)
- 7,400 psi (510.2 bar) PULL
3.200 psi (220.6 bar) RETURN
- GB940 Powerunit or equivalent
- Fire resistant hydraulic oil conforming with
OSHA regulation 1926.302.
- 1.437" (36.5mm)
- 17,745 lbs. (78.9 kN) @ 6,500 psi (448.2 bar)
-
81.5 dB (A)
- Tested – No hazards found.
4
REV. 9/18