Gage Bilt GB3585A Оригінальна інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Електроінструмент Gage Bilt GB3585A. Gage Bilt GB3585A 20 сторінок. Installation tool
Друкувати сторінкуWhen the tool is connected to a hydraulic powerunit, operation is controlled by an electric actuator (GB3585) or a piloted air actuator
(GB3585A) in the handle. When the actuator is depressed, a directional valve in the hydraulic powerunit directs oil to the front side of
the piston forcing it and the internal component in the nose assembly rear-ward. This action causes the jaws to clamp onto the fastener
pintail and pull the sheets together. The anvil is forced forward, swaging the collar into locking grooves of the fastener. Further force
breaks the pintail off, approximately flush with the collar. When the piston is in the rear position flats are exposed unloading the
pressurized oil.
When the actuator is released, the directional valve directs the oil to the back of the piston pushing the nose assembly off of the
swaged fastener. The pintail ejector hydraulically pushes the spent pintail out of the nose assembly. When the piston is full forward
pressure is built shutting of the hydraulic powerunit.
PULL Cycle
Pintail
Ejector
Piston Travel
Actuator
Pressurized Oil
GB3585/GB3585A INSTALLATION TOOL
PRINCIPLE OF OPERATION
HYDRAULIC DIAGRAM
Pintail
Ejector
Relief
Valve
Unpressurized Oil
Pressurized Oil
Unpressurized Oil
Images may not reflect actual tool
7
RETURN Cycle
Actuator
Unpressurized Oil
Pressurized Oil
Piston Travel
Relief
Valve
5/19