Gage Bilt GB740 Оригінальна інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Електроінструмент Gage Bilt GB740. Gage Bilt GB740 20 сторінок.
Також для Gage Bilt GB740: Посібник з монтажу (12 сторінок)
Друкувати сторінку
When the actuator is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the valve spool
assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward direction.
The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool. Simultaneously,
the piston rod assembly, connected to the air piston assembly, is also moving down, forcing hydraulic oil up and into the front side of
the head cylinder, causing the piston assembly to move to the rear of the head cylinder. The internal components of the attached nose
assembly are also moving with the piston assembly to start the fastener installation. When the fastener installation is completed, the
actuator is released. Air pressure is then built up inside of the handle assembly causing the valve spool assembly to return to its
original position and reversing the sequence directing air pressure to the rear of the head cylinder, causing the piston assembly to
move to the forward position.
Piston Travel
Air exhaust
Piston Rod Assembly
moves down
Air Piston
moves down
GB740 S/N 1175 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
PRINCIPLE OF OPERATION
PULL Cycle
Air exhaust
Pressurized Oil
Unpressurized Oil
Image may not reflect actual tool
Piston Rod Assembly
moves up
Air Piston
moves up
Pressurized Air
Unpressurized Air
7
RETURN Cycle
Piston Travel
Air exhaust
Rev. 5/22