Gage Bilt GB745SHAVT Оригінальна інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Заклепочні інструменти Gage Bilt GB745SHAVT. Gage Bilt GB745SHAVT 20 сторінок. Installation tool

Друкувати сторінку

WARNING:

Do not cycle tool without air bleeder assembly (704153), or the screw and stat-o-seal, installed in tool head. Severe

personal injury could result.

WARNING:

Use CAUTION when removing screws, air bleeder assembly (704153) and fill bottle (745263). Hydraulic oil may be

under pressure.

CAUTION:

When bleeding tool, ensure tubing is free from kinks or other obstructions.

1. Disconnect air supply from the powerunit.

2. Fill oil reservoir approximately 3/4 full. Use hydraulic oil (AW-32 or equivalent).

3. Carefully remove button head cap screw (402482) and stat-o-seal (S572) from hole (marked #1) on the right side of head cylinder (745366).

4. Provide a suitable container to bleed oil into.

5. Reduce air pressure to 40 psi. (2.76 bar) during bleeding procedure. Connect air supply to powerunit.

6. Point the bleed port towards a container, push lever (704345) down and hold. (Block bleed port using a small piece of rubber material

before releasing lever (704345) to prevent ingestion of air into powerunit).

7 Repeat until clear oil streams from port. Check reservoir after each cycle and refill when required. Do NOT drain reservoir below minimum.

8. On last cycle of oil, hold lever (704345) down. Install button head cap screw (402482) and stat-o-seal (S572) prior to releasing the lever

(704345) and torque to 35-40 inch lbs. (3.95 - 4.52 Nm). (Do NOT over-tighten)

9. Check stroke of .620" (15.8 mm) using instructions a thru c and diagrams below. We recommend using dial calipers.

a. With the lever (704345) released, check dimension (A).

b. Holding lever (704345) in, check dimension (B).

c. Subtract dimension (A) from dimension (B). If stroke is not consistent within 1/64" (.0156) repeat steps 1-9 until stroke met.

For your consideration, Gage Bilt offers a depth gage (Pt.# A-1935) to help simplify and more accurately check your tool stroke.

Please contact Gage Bilt for more information.

HANDLE/TOOL

GB745SHAVT INSTALLATION TOOL

FILLING AND BLEEDING PROCEDURE

Bleed port

Images may not reflect actual tool

Fill oil reservoir approx. 3/4 full

BOOSTER

7/21 REV 5/22