Active Silicon HARRIER 18x AF-ZOOM HMDI 4K CAMERA Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Цифрова камера Active Silicon HARRIER 18x AF-ZOOM HMDI 4K CAMERA. Active Silicon HARRIER 18x AF-ZOOM HMDI 4K CAMERA 9 сторінок.

Друкувати сторінку

QUICK START GUIDE

HARRIER 18x AF-ZOOM HMDI 4K CAMERA

Version 1.0.0 - September 2021

The HarrierControl application is used in the Command Prompt window with command line

arguments as follows:

HarrierControl [P1] [P2] [P3] [P4]

Argument [P1]:

This specifies the type of interface/serial communication to be used.

displays help text.

RS232 RS-232 comms via Harrier Evaluation Kit Board selected.

RS485 RS-485 comms via Harrier Evaluation Kit Board selected.

TTL

TTL comms via Harrier Evaluation Kit Board selected.

USB3

USB comms selected.

COMx

COM port x selected, (x=2-255).

Argument [P2]:

This specifies the Baud Rate of the serial port. Valid values are 9600, 19200, 38400, 57600 and

115200.

With USB3 communications [P2] is not required and is omitted from the command line.

Argument [P3]:

This is the VISCA command that is to be sent to the camera.

The application requires VISCA commands to be entered in a comma delimited format; the commas

are removed before sending the commands.

Each individual number is treated as a hexadecimal number.

To work in PowerShell the comma separated VISCA command should be enclosed in double

quotation marks: " ** "

For information on available VISCA commands please refer to the documentation for your camera

Argument [P4]:

This is an optional parameter. If you set [P4] to /P HarrierControl will attempt to parse the

command and response and print a description of the command/response on the screen.

Note: only a few commands are supported so there may be no description for many commands.

September 2021

Page 7 of 9