Dyna-Glo RA18LPDGP Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Обігрівач Dyna-Glo RA18LPDGP. Dyna-Glo RA18LPDGP 16 сторінок. Propane construction heater
Також для Dyna-Glo RA18LPDGP: Посібник користувача (19 сторінок)
Друкувати сторінку
PROPANE CONSTRUCTION HEATER
1. Unit
2. Rear Guard
3. Manual
4. Hardware Kit
Includes:
M8 Flat Washers(4) Locking Casters(2)
(VWLPDWHG $VVHPEO\ 7LPH
1. Remove heater from carton.
2. Remove all protective packaging applied to heater for shipment.
5HWDLQ FDUWRQ DQG SDFNLQJ PDWHULDO XQWLO \RX FRQ¿UP WKH XQLW RSHUDWHV DQG LV IRXQG LQ JRRG FRQGLWLRQ
4. Check heater for any shipping damage. If heater shows any external or internal damage, promptly inform
dealer/distributor where you purchased heater.
5HPRYH EDFN FRYHU
6. Locate the four (4) casters shipped with the unit. There are two (2) locking casters and two
QRQORFNLQJ FDVWHUV $OVR ¿QG WKH IRXU ZDVKHUV DQG ZUHQFK VKLSSHG ZLWK WKH FDVWHUV
7. Carefully lay the unit on its back.
8. Place one washer on each of the threaded portions of the caster. (see Figure 1).
9. Thread the casters into the four threaded holes in the base of the unit by turning them
clockwise
. The locking casters should be placed at the front of the unit and the other two
at the back of the unit. (See Figure 1).
10. Tighten The casters using the wrench supplied with the casters.
11. Install 20 lb propane cylinder. (see Propane Supply section)
,QVWDOO EDFN FRYHU E\ LQVHUWLQJ WKH PRXQWLQJ WDEV LQWR WKH VORWV RQ WKH UHDU ÀDQJH RI WKH KHDWHU
CAUTION: The casters must be installed onto the unit before it is used. Failure to install the
FDVWHUV PD\ UHVXOW LQ D ¿UH RU H[SORVLRQ FDXVLQJ SURSHUW\ GDPDJH SHUVRQDO LQMXU\ RU ORVV RI OLIH
FIGURE 1
CONTENTS
10 Minutes
UNPACKING THE HEATER
1-877-475-5660
Non Locking Casters(2) 14 mm Wrench(1)
Tools Required:
14 mm Wrench (Included)
WASHER
LOCKING CASTERS
NON-LOCKING CASTERS
WRENCH INCLUDED WITH CASTERS
1-877-475-5660
6