GREAT ARBOR Thuraya XT-Hotspot Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий маршрутизатор GREAT ARBOR Thuraya XT-Hotspot. GREAT ARBOR Thuraya XT-Hotspot 14 сторінок.

Друкувати сторінку

PC or other user device connected to the XT-Hotspot (via WiFi or LAN) attempts to access the Internet,

the XT-Hotspot will initiate a GmPRS connection. Enter the time after which the XT-Hotspot should

automatically disconnect the connection in case of no activity (180 seconds is recommended). Setting the

time to 0 changes the XT-Hotspot from Automatic Mode back to Always-On mode in which it will

automatically open a connection and keep it up after being powered up. Press

to save any

Save & Apply

changes made to the configuration.

Figure 4 GMPRS On-Demand Mode Configuration

In On-Demand mode various programs on your laptop (Virus update, Windows Update, etc.) or other

WiFi device may attempt to access the Internet without your knowledge and will trigger a data connection.

One way to disconnect the data connection is to disconnect the WiFi connection on your laptop/device.

The data connection will be automatically dropped after the "Inactivity timeout" number of seconds.

Another way is to turn the XT-Hotspot off or pull the USB cable out

WiFi Security

Your WiFi connection can optionally be made secure if you want to be sure that no one else accesses the

Internet using your GmPRS connection or accesses your PC over WiFi. Click the

tab (located under

Wifi

the Interfaces option) in the Network section and the Wireless Status and Configuration page will open

up as shown in Figure 5. Click the "Edit" button on the right to edit the WiFi configuration. Click the

Wireless Security tab in the lower section to set encryption as shown in Figure 6. The most secure form of

encryption is WPA2-PSK and the key can be a mixture of characters and letters. If your device does not

support WPA2-PSK, you can set the encryption to WEP. However in the case of WEP, the key has to be

characters. After making the entries, click

exactly 10

Save & Apply