Dawnco DIGISAT PLUS Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Вимірювальні прилади Dawnco DIGISAT PLUS. Dawnco DIGISAT PLUS 2 сторінки.

SIMPLIFIED OPERATING INSTRUCTIONS (continued)

4) DIGISAT comes on in the most signal sensitive mode by default.

5) If the LED bar reading maxes out, push the left yellow button once to desensitize the

DIGISAT and then fine tune the antenna for maximum DIGISAT reading. Note: the LED

readings will not be equal to the satellite receiver meter readings. Two different metering

methods are utilized. Tune the dish for the maximum reading from the DIGISAT and then

tighten the dish mounting bolts.

6) To measure LNBF current consumption push the right yellow button one time, (the Mode

light will come 'on' ). Read the lower LED bar graph. Each lighted segment equals 50mA (3

lighted segments = 150mA). Normal LNBF current draw is 100 to 150mA. No current

consumption indicates non functioning, open circuit LNBF. High current consumption

above 250mA also indicates a defective LNBF.

7) To measure voltage of the Ni-Cad battery pack the Mode light must be 'on'. Read the

voltage on the upper LED bar graph. Each segment in this scale equals one volt plus ten

volts . For example if three (3) LED segments are lit then the voltage is thirteen (13) volts

DC. This feature measures the charge of the internal rechargeable battery pack. If the

battery pack reads ten (10) volts or less, recharge the batteries.

8) To measure voltage provided from a satellite receiver, disconnect the internal battery pack

and connected the satellite receiver's RG-6 to the bottom "F" connector of the DIGISAT.

Make sure the Mode light is 'on'. The DIGISAT will then display the voltage the receiver is

providing to the LNBF. Make sure you disconnect the battery pack first. Failure to do so

can damage the DIGISAT. Receivers will typically provide 14 or 18 volts DC to a LNBF

depending on the appropriate polarization required for the channel selected on the

receiver.

ADDITIONAL HELPFUL HINTS

1) Charge the battery pack fully before you start to use it. DO NOT leave the DIGISAT battery

pack on either charger indefinitely. Long periods of charging will overheat the batteries

and drastically reduce battery life.

2) DO NOT connect the female plug from the battery pack to the male pigtail socket. THIS

WILL SHORT OUT THE BATTERY PACK and destroy the battery pack or melt the lead

wires.

3) If you are using the battery pack to power the DIGISAT, turning the power 'off' and 'on'

again will restore the default (high signal sensitivity) level. If you are powering the

DIGISAT with a satellite receiver, disconnect the coax from the receiver momentarily to

restore the DIGISAT to the most sensitive (default) mode.

4) The POWER 'on'/'off' function is disabled when a satellite receiver is connected to the

DIGISAT. The POWER button controls the battery pack power supply connection only.

DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • [email protected]

You are entitled to the manufacturer's limited express warranty, if any, that accompanies the product. DAWNco makes no

additional or independent warranty. All other warranties, express or implied, including the warranties of merchantability and

fitness for a particular purpose are disclaimed. We do our best to be accurate. We are not responsible for any typographical,

photographic or technical errors. See "Policies for DAWNco" under the "Answers" button at the DAWNco web site.

DG-2 Plus

Ver 1.6