Great day UVFR751 Інструкція по встановленню та використанню - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція по встановленню та використанню для Автомобільні аксесуари Great day UVFR751. Great day UVFR751 5 сторінок. Utv front rack
Друкувати сторінку
STEP 1: SEE FIG. 1 (PAGE 4)
ATTACH HORIZONTAL SUPPORT ANGLES TO UTV ROLL BAR
APPROXIMATELY LEVEL WITH THE TOP OF UTV'S HOOD USING 2 – 5/16"
X 2" U-BOLTS, WASHERS & LOCKNUTS PROVIDED.
(THESE BRACKETS HAVE 3 HOLES ON ONE SIDE.)
**NOTE** #1: IF THE UTV HAS A WINDSHIELD, REMOVE BOLT FROM
BOTTOM WINDSHIELD CLAMPS, SUBSTITUTE SMALL ANGLE BRACKETS,
WHICH HAVE 1 HOLE ON EACH SIDE, AND PLACE CLAMP BOLT
THROUGH ANGLE AND BACK TO CLAMP.
STEP 2: SEE FIG. 2 (PAGE 4)
MEASURE THE DISTANCE BETWEEN ANGLE SUPPORTS. ATTACH F-
SHAPED HORIZONTAL RACK SUPPORTS TO FRONT RACK USING 4 – 1/4" X
3 1/2" BOLTS, WASHERS AND LOCKNUTS PROVIDED. SELECT THE PROPER
HOLES TO ACHIEVE DESIRED WIDTH FOR SUPPORT BARS TO REST ON
THE ANGLE SUPPORTS.
STEP 3:
USING 5/16" X 2 ¼" BOLTS, WINGKNOBS & MEDIUM NYLON WASHERS,
CONNECT SUPPORT BARS TO ANGLE BRACKETS. WHILE HOLDING THE
FRONT RACK LEVEL, MEASURE FROM CENTER OF HOLE IN ANGLE ON
THE FRONT OF RACK TO THE BRUSH GUARD OF UTV. THIS
MEASUREMENT WILL DETERMINE WHICH SET OF VERTICAL SUPPORT
BARS YOU NEED.
STEP 4: SEE FIG. 3 (PAGE 4)
ATTACH SELECTED SUPPORT BARS TO ANGLES ON THE FRONT OF RACK
USING 2 – 1/4" X 1 3/4" BOLTS, WASHERS, NYLON WASHERS AND
LOCKNUTS PROVIDED. NYLON WASHERS SHOULD BE INSTALLED
BETWEEN ANGLE AND SUPPORT BARS. DO NOT OVER TIGHTEN
HARDWARE.
PAGE 2