Hi-Force ALUMINIUM HP232 Інструкція з експлуатації Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Водяний насос Hi-Force ALUMINIUM HP232. Hi-Force ALUMINIUM HP232 15 сторінок. Hp-manually operated hydraulic pump
Також для Hi-Force ALUMINIUM HP232: Інструкція з експлуатації (6 сторінок)

Hi-Force ALUMINIUM HP232 Інструкція з експлуатації Посібник з експлуатації
6.1 Before First Use / Preparation
Check for any signs of wear in the pump or connected components.
Unscrew the transit plug (3) and fit the breather (4) this will maximise the oil volume available and
prevent oil reservoir pressure build up.
6.2 Filling the Pump with Fluid - ISO15 grade.
IMPORTANT:
Only add fluid to the reservoir when the connected system is fully de-pressurised and
returned to its closed position. Failure to do so will result in the system containing more fluid
than the reservoir can hold.
Fill / top-up the pump as follows:
Stand the pump on a firm, level surface.
Remove the transit plug/breather (3/4) from the reservoir.
Fill the reservoir with clean, high quality ISO15 hydraulic oil, leaving a small air space of
approximately 1-2cm between the top of the fluid and the filler plug.
Replace the transit plug/breather (3/4).
6.3 Hydraulic Connections
Remove the hexagon headed plug and make a hydraulic connection to the outlet port (6). This port has a
3/8" NPT female thread, and the connection should be sealed, as appropriate, with a suitable thread sealant.
DO NOT overtighten this fitting. It can cause damage to the pump head or lead to failure
of the fitting at below rated pressure.
When making a connection between two couplers, ensure that these connections are fully connected, with
no thread gap and hand tight only.
To do so: Ensure that all threads are clean with no damage [1] Press the male coupler into the female
coupler, [2] then turn the threaded-collar clockwise (by hand) until the threads are fully engaged.
Operating Instruction Manual:
OM-HP-ALUMINIUM-01

6.0 Installation / Setup

9
Serial Numbers:
From: DF2001