6TL YAV90CIN Технічний опис - Сторінка 8
Переглянути онлайн або завантажити pdf Технічний опис для Реле 6TL YAV90CIN. 6TL YAV90CIN 13 сторінок. 12-channel 5a general purpose relays
Друкувати сторінку8.
LED BEHAVIOUR
LED Name
LED Behaviour
STATUS
Off
Solid green
LED behaviour
9.
SWITCH CONFIGURATION
Switch
Name
SW1
1 & 2
3 to 8
SW1 behaviour
Switch ID
SW2
BOOT0
SW3
RESET
SW4
CAN-END
Switches description
Board is not powered on, power supply is not reaching the
microcontroller, or firmware of microcontroller is not present or is not
running due to an error.
Board is powered on, and firmware is running properly.
Pin switch
Switches 1 and 2 set the CAN communication speed:
The logic address is composed by 2 elements: the module
identification and the hardware address. The module identification is
set on firmware and cannot be changed. The hardware address is
selected by switches 3 to 8, being 3 the least significant bit (LSB) and
8 the most significant bit (MSB):
Description
Factory use. Must be OPEN on operation.
Must be OPEN on operation. A temporary bridge causes a reset of the board.
Placing jumper adds a 120 Ohm resistor between the CAN-High and CAN-Low
signals of CAN-Bus.
Definition of Behaviour
Definition of Behaviour
00 = 50 kbps
10 = 100 kbps
01 = 125 kbps
11 = 250 kbps
ON
ON=1
OFF=0
1 2 3 4 5 6 7 8
LSB
MSB
Board Address
Definition of Behaviour