Active Tools CoxOrb Platinum Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Active Tools CoxOrb Platinum. Active Tools CoxOrb Platinum 8 сторінок.
Друкувати сторінкуConfigure Area 1
Configure Area 2
Configure Area 3
Enter Recall
1
2
Configuring the Display
Press & hold DISPLAY and press DECREASE VOLUME
to cycle between Stroke Count, making this area blank,
and Check Factor.
Press & hold DISPLAY and press INREASE VOLUME to
cycle between 'SPEED' , Average Speed (AS), and Distance
per Stroke ( ). Distance Per Stroke is displayed as, for
example, 9.52 (metres) and its symbol is not displayed
after it has been selected. If it goes over 10 the 1 is not
displayed, eg: 12.53 will be displayed as 2.53
Speed can be displayed in metres/sec or splits (minutes
and seconds/500 metres). To change between them press
and hold 'DISPLAY' and 'CLOCK' buttons for 3 seconds. The
display will alternate between 'Str-AVG' 'SPd-SPL' , 'I-CAL'
and ICF-SEt at 2 second intervals. Release the buttons to
select 'SPd-SPL' and use the Volume buttons to choose
between Speed (SPd) or Split (SPL) readings.
Press DISPLAY to swap between 'DIST' and 'TIME'
If you want to display alternating 'DIST' and 'TIME' press
and hold DISPLAY for 8 seconds (to exit this mode press
DISPLAY for 3 seconds)
Note that when 'DIST' and 'TIME' are alternating in a
workout and you pass 250 metre marks the time will stay
on screen for 5 seconds (unless you are doing a
pre-programmed work piece based on minutes when it will
display distance for 5 seconds every complete minute).
Recall
Press RECALL.
When in 'RECALL' mode 'MEM' is displayed on screen and
the most recent work piece is numbered '01' .
3