DAYCO D165DC Посібник оператора - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник оператора для Обтискний інструмент DAYCO D165DC. DAYCO D165DC 19 сторінок.

D165DC QUICK START GUIDE

FOLLOW THESE STEPS BEFORE YOU USE YOUR

CRIMPER FOR THE FIRST TIME

CALIBRATION CHECK FOR THE D165DC

(See the following page for D160S-DC Calibration)

PLUG THE CRIMPER DIRECTLY INTO A 110 VOLT 20

AMP SINGLE PHASE WALL OUTLET.

DO NOT USE AN EXTENSION CORD OR RUN FROM

PORTABLE POWER SOURCES AS LOW VOLTAGE CAN

DAMAGE THE MOTOR.

THE OIL LEVEL IN THE PUMP SHOULD BE APPROX.

1 1/2 INCHES BELOW THE FILLER/VENT PLUG.

PLACE THE STANDARD PRESSURE

PLATE, ANY STANDARD DIE SET AND THE

STANDARD COMPRESSION RING IN THE

BASE OF THE CRIMPER IN THE ORDER

SHOWN.

SLIDE THE PUSHER ONTO THE

STUD OF THE HYDRAULIC RAM.

SET THE MICRO-CRIMP ADJUSTER

AT "95".

PRESS AND HOLD THE START SWITCH.

IF THE RAM EXTENDS AND SHUTS OFF THE MOTOR

IN APPROXIMATELY ONE SECOND AFTER THE PUMP

STARTS TO BUILD PRESSURE, (THE SOUND OF THE PUMP

WILL CHANGE) AND THE DIE SET IS FULLY CLOSED, THE

CRIMPER IS CORRECTLY CALIBRATED.

IF THE TIME TO SHUT OFF IS NOT APPROXIMATELY

1 SECOND, THE CRIMPER MUST BE RECALIBRATED. SEE

INSTRUCTIONS.

Page