GREAT PLAINS 7000 Series Посібник з налаштування - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з налаштування для Сільськогосподарське обладнання GREAT PLAINS 7000 Series. GREAT PLAINS 7000 Series 4 сторінки. Disk harrow
Друкувати сторінкуHydraulic Single Point Depth Stop Adjustment:
The hydraulic depth stop will ensure a consistent depth
every time the machine is lowered.
1) Prior to setting the single point depth stop, ensure
that the machine is completely level front to back and
side to side.
2) Lower the machine to the desired working depth and
pull forward. Once satisfied with the working depth,
adjust the depth stop handle to make contact with the
depth stop valve.
Note: If a change of depth is desired,
1 full turn on the depth stop handle either in or out will
change the depth of the machine approximately 1/4" up
or down.
Gauge Wheel Adjustment:
Note: The gauge wheels are desired to run 1/2" above
the ground when operating in the field.
1) With the machine lowered into the desired operating
position, remove the wire retaining pin and adjust the
gauge wheel crank either up or down until the gauge
wheels are 1/2" above the ground.
wheels are designed to correspond to the single point
depth stop. If the depth stop is increased one full revolu-
tion then the gauge wheels need to be increased one
full revolution, ect.
Spike Drag Adjustment:
Spike drags come factory set with 5 chain links hanging
from the bottom drag arm slot. The cleaner the ground,
the shorter the pull chains may be pulled up.
Ensure that the spike drag is never pulling off of the
hang chains. If so, shorten the chains.
Note: The gauge
Note:
3 of 4
49393
49394
48746
Document
#TLUS100C-0001B