Hi-Tech 22-229 Інструкція з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пила. Hi-Tech 22-229. Hi-Tech 22-229 16 сторінок.

OILING

The only parts you need to oil on the trim saw

machine is the inside of the aluminum arbor and

the motor shaft (Fig. E). This is required because

the motor shaft and arbor are made of different

materials. Over time, they can seize together,

making it impossible to remove the arbor from

the shaft. Every two months or so, remove the

arbor from the motor shaft by loosening the two

set screws using the included Allen wrench, turn-

ing counter-clockwise. Once loosened, slide the

arbor off the motor shaft. Apply a few drops of

motor oil, way oil, lithium or water pump grease

inside the arbor where it fits onto the shaft. Also

apply a few drops of oil or grease onto the motor

shaft, rubbing to coat the shaft lightly. Make

sure there is no excess oil so that oil doesn't drip

down the motor shaft and get into the motor.

This will cause an instant motor burn-out.

Replace the arbor onto the shaft, using the Allen

wrench to tighten the two set screws.

Motor shaft with grease

MAINTENANCE

Arbor

Fig. E

CLEANING

After each use, drain the water reservoir. Any used

water must not be disposed down a sink, as rock

sediment can harden like cement, closing off

the drain. Dry the machine and saw blade with

paper towels or a cloth. You may also spin dry the

saw blade by running it on the trim saw until it is

completely dry. Notes: Always dry your saw blade

after each use to prevent rusting. Keep out of reach

of children.

FUSE DETAILS

The fuse is installed in the back of the trim saw

machine. It is a 250V, 2AMP slo-blo cartridge fuse.

If you need a replacement, this fuse can be found

at your local hardware store. See Fig. F for how to

change the fuse.

Push in with a flat head screwdriver, then turn to the left

(counter-clockwise)

Fig. F