Ceia HI-PE/CF Series Додаткова інформація - Сторінка 8
Переглянути онлайн або завантажити pdf Додаткова інформація для Металошукач Ceia HI-PE/CF Series. Ceia HI-PE/CF Series 11 сторінок.
Друкувати сторінку
8
Code
Meaning
International
IS
Security
Standard
Transmitter
TI
inhibitor
ANALYSIS PROGRAMS AVAILABLE WITH THE COMMAND "IS"
DISPLAY
PROGRAM IS
MESSAGE*
1
N I L . 1
2
N I L . 2 B A
3
N I L . 3 B A
4
N I L . 2 A D
5
N I L . 3 A D
6
H I G H I M M
* The display message also appears when not in programming if the
The unit is programmed in the factory to ensure operation according to the IS standards for the passage width
listed in the "Hardware and software configuration sheet" included at the end of the manual. If, for any reason,
the passage width has been changed, this correspondence is not guaranteed .
02PN8 HI-PE/CF --- Rev. F044GB60K10
Possible
Type
Notes
values
Display indication: When the value is under the alarm threshold, the indication is green,
when the value is above the alarm threshold, the indication is red.
see the
C,R
followin
g table
NO,
Deactivates the transmitter if the Metal Detector is inhibited.
YES
The Metal Detector behaves as follows in the two different situations:
TI=NO the metal detector is immediately operational when the inhibition signal
TI=YES when the inhibition signal is switched off, the Metal Detector resets; in
inhibition
Delay before the metal detector is operational with TI=ON: after deactivation of
the inhibition signal, it is necessary to wait for time tr before the detector
reactivates
SECURITY LEVEL / APPLICATION
Standard : NILECJ-STD-0601.00 Security Level 1
Standard : NILECJ-STD-0601.00 Security Level 2
Basic specifications
Standard : NILECJ-STD-0601.00 Security Level 3
Basic specifications
Standard : NILECJ-STD-0601.00 Security Level 2
Additional specifications
Standard : NILECJ-STD-0601.00 Security Level 3
Additional specifications
Level
with
interference (corresponding approximately to level
NILECJ 2, with additional specifications).
is switched off
this case, it is necessary to wait a few moments (0.5 – 2 sec) before the
Metal Detector is operational (tr in the diagram below)
signal
TX
alarm
relay
high
immunity
to
inhibition
TX inactive
normal
reset
operation
tr
0,5 - 2s
SAMPLES
AM9
AM7
AM5
AM7; AN7
AM5; AN5
environmental
-
key is pressed.
Fig. IV-1