Hi-Tech Diamond 31-004 Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пила. Hi-Tech Diamond 31-004. Hi-Tech Diamond 31-004 16 сторінок. 10" slab saw

Before you make the first cut, line up your

rock or glass properly with the saw blade.

Lightly slide the material into the saw blade until

a groove forms, then push the material firmly

through the saw blade. Do not attempt to cut

curves with the trim saw, it is designed to cut

straight lines only. As you near the end of the

cut, reduce pressure to avoid a sudden "break-

through". Reducing pressure also gives you a

cleaner cut. Note: Never force a saw blade, let the

blade do the work.

This slab saw is to be used for slabbing larger

material. The rocks and glass you are sawing

should never exceed more than 2/3 the size of

the visible cutting area of the saw blade. The

blade height of the 10" slab saw is 3-3/4". This

measurement is taken from the saw table to the

top of the saw blade (Fig. D).

CUTTING TIPS

Fig. D

The red saw blade included with your saw

has a sintered diamond rim that may require

"sharpening" or "dressing" over long, continuous

use. Simply put, the diamonds embedded into

the sintered matrix of the blade are wearing

down, and the metal sintered matrix surrounding

the diamonds are deforming over them. This

metal matrix needs to be abraded away to

expose the diamond surface. Dress and sharpen

sintered saw blades with aluminum oxide, silicon

carbide stone, dressing stick or brick. Run 3-4

times through the saw blade for a quick fix. Note:

Always abide by your saw blade instructions. Not

all saw blades should be sharpened or dressed, as

it can ruin the saw blade.