DYNACO SCA-80Q Посібник - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник для Підсилювач DYNACO SCA-80Q. DYNACO SCA-80Q 12 сторінок. C9 replacement
Також для DYNACO SCA-80Q: Посібник з монтажу (15 сторінок)
Друкувати сторінку
a. Remove 4" of insulation from the supplied 20 AWG wire.
b. Cut the resulting bare wire into two 2" long pieces.
c. Twist and shape the wires as shown in Figure 3.
6. Solder the center section as indicated. Place the soldered portion of the jumper in
the center of the dynamite capacitor configuration. Hook the ends of three of the
four wires to the three negative terminals of the capacitors. Solder the wires to the
negative terminals.
7. Form the remaining wire upward, away from the caps. You'll attach it to the
amplifier ground connection in a later step.
8. Prepare the Positive Wire Harness as follows (see Figure 4):
a. Cut two pieces of red 20 AWG wire, each to a length of 2".
b. Remove ¼" of insulation from the ends of the wires (4 places).
c. Form the bare ends into hooks. Crimp the hooks around the positive
terminals of the capacitor as shown in Figure 4. Solder the connections,
making sure to leave room for additional wires added in later step
Figure 4-Soldering the ground and positive harnesses on the new C9 dynamite capacitor
Figure 3-Ground Harness Configuration
arrangement
Page 6 of 12