ADEMCO LYNXR24 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Система безпеки ADEMCO LYNXR24. ADEMCO LYNXR24 8 сторінок.
Також для ADEMCO LYNXR24: Посібник із швидкого старту (8 сторінок)
Друкувати сторінку
WARNING:
TO PREVENT
RISK OF
SHOCK
DISCONNECT
TELEPHONE
RJ11
LINE AT TELECOM
JACK BEFORE
SERVICING
THIS UNIT.
TO HANDSET
PHONE
LINE
ALL OUTPUT
CIRCUITS
ARE POWER
LIMITED.
LOCAL SOUNDER
DISABLE JUMPER
CUT = DISABLE
THIS EQUIPMENT SHOULD BE INSTALLED IN
ACCORDANCE WITH THE NATIONAL FIRE PROTECTION
ASSOCIATION'S STANDARD 72, CHAPTER 2 (NATIONAL
FIRE PROTECTION ASSOC., BATTERYMARCH PARK,
QUINICY, MA 02269).
PRINTED INFORMATION DESCRIBING PROPER
INSTALLATION, EVACUATION PLANNING AND
REPAIR SERVICE IS TO BE PROVIDED WITH THIS
EQUIPMENT.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
LYNXR IS EQUIPPED WITH AN INTEGRAL
RECHARGABLE BATTERY PACK P/N LYNXRCHKIT-SC.
REPLACE EVERY FOUR YEARS.
LYNXR24 IS EQUIPPED WITH AN INTEGRAL
RECHARGABLE BATTERY PACK P/N LYNXRCHKIT-HC.
REPLACE EVERY FOUR YEARS.
System Programming
Step
Set a programming default as follows:
1.
a.
Enter Programming mode: Installer Code + 8 0 0.
b.
Press *97, then press a number 1-4 to select a default table from the tables listed on page 1.
Program the variable data fields as follows:
2.
a.
RF House ID - Press *24, then enter the desired 2-digit RF House ID for wireless keypads.
b.
PABX Access Code (if used) - Press *40, then enter up to 6 digits. If fewer than 6 digits are used, press [*] to
end the field and advance to the next field.
c.
Primary Phone Number - Press *41, then enter the primary phone number, up to 20 digits. If fewer than 20
digits are used, press [*] to end the field and advance to the next field.
d.
Secondary Phone Number (if used ) - Press *42, then enter the secondary phone number, up to 24 digits. If
fewer than 24 digits are used, press [*] to end the field and advance to the next field.
e.
Secondary Account Number (if used) - Press *44, then enter the secondary account number. If only 3 digits
are used, press [*] to end the field and advance to the next field.
f.
Pager Characters - Press *88 if using Default Table 2 or 4, then enter up to 16 digits which may be required
by your pager service (e.g. account number, PIN, etc.). If fewer than 16 digits are used, press [*] to end the
field and advance to the next field.
g.
Download Phone Number - Press *94, then enter the downloading computer phone number, up to 20 digits.
If fewer than 20 digits are used, press [*] to end the field.
EARTH
GROUND
PHONE
8
1
2
3
4
5
POSITION
JACK
TIP
RING
TIP
RING
INCOMING
PHONE
LINE
INCOMING
TELEPHONE
LINE
EARTH
PREMISES
GROUND
TELEPHONE
WEEKLY TESTING IS
REQUIRED TO ENSURE
PROPER OPERATION
OF THIS SYSTEM
FCC ID: CFS8DLLYNX COMPLIES WITH FCC RULES,
PART 68 FCC REGISTRATION No. 5GBUSA-25623-AL-E
RINGER EQUIVALENCE: 0.6B
LYNXR/LYNXR24 WIRING CONNECTIONS
AAV
TRIGGER
ZONE
SOUNDERS
11
12
13
6
7
8
9
10
(+)
( )
( )
(+)
DATA
( )
(+)
OUT
HARD
WIRED
ZONE
PIEZO
BELL
2k OHMS
6-14VDC
EOLR
30mA max.
6-14VDC
120mA max.
(e.g. WAVE2EX)
Action
-3-
PLCD
AC
14
15
16
SYNC
IN
NOTE
USE ONLY
1332/1332X10
OR 1332CN
TRANSFORMERS
PROVIDED
TO 24HR 110VAC
UNSWITCHED
OUTLET
AC
AC
SYNC
COM
DATA
PLUG-IN
TRANSFORMER
9VAC, 15VA
1332/1332X10/1332CN
CONNECTIONS
1332X10 ONLY
CONNECTIONS
01000-015-V0