Aircraft in Miniature Limited 747-100 Історія, примітки та інструкції - Сторінка 6

Переглянути онлайн або завантажити pdf Історія, примітки та інструкції для Іграшка Aircraft in Miniature Limited 747-100. Aircraft in Miniature Limited 747-100 16 сторінок. Transport wings history, notes and instructions 1:72 multi-media kit. the world’s first wide-body airliner

Друкувати сторінку

(a) Use the templates enclosed to make the components of the

(b) Glue the five

degrees to the adjacent side (see Figure A below).

(3) Attach the nose leg (marked 100) to the upper face of the nose

landing gear bay structure, with the pins in the holes in the side panels.

Do not attach the detail parts yet.

(4) Put half the depth of the keel into one fuselage half and cement it in place

with liquid polystyrene cement.

(5) File the visible part of the keel to match the curvature of the second

fuselage half.

(6) Cement the nose landing-gear bay structure to the fuselage half and

keel.

(7) Put the tailplane in place in the two fuselage halves.

(8) Clip the second fuselage half on to the keel. Flood the joint with liquid

polystyrene cement, hold the two halves together with adhesive tape,

and leave the assembly until is thoroughly dry.

WING SUB-ASSEMBLY

NOTE - We recommend that you put a wooden spar (not provided) into each

wing to prevent them drooping with age. This is very important with this

model because of the weight of the four resin engines.

A Sand the wing parts to their correct shape and make sure they fit t o g e t h e r

correctly.

B Prepare a wooden spar for each wing. Assemble the top and bottom of the

wings with the spars in place, WITHOUT ANY CEMENT to make sure that

they fit correctly.

C Cut the main landing gear doors out from the wing lower surface (see Figure

C), and keep them.

D Make the main landing-gear bays

(1)

Make the components of the two main landing-gear bays from the 2 mm

plastic sheet supplied.

nose landing gear bay from the 2 mm plastic sheet supplied.

= glue here

Nose Landing Gear Bay Structure

components together with each side at 90

(Two handed sub-assemblies)

Nose gear leg

in place