HiB Paragon 80 Швидкий старт Quide - Сторінка 3

Переглянути онлайн або завантажити pdf Швидкий старт Quide для Внутрішнє оздоблення приміщень HiB Paragon 80. HiB Paragon 80 4 сторінки.

Друкувати сторінку

3. Before drilling, ensure there are no hidden cables

or pipes behind the mounting points. Using a

suitable drill bit, drill holes in the marked positions

to a suitable depth.

4. Insert wall plugs level with the surface of the wall.

If fitting to a tiled surface, wall plugs should be

inserted below the tile surface to avoid cracking.

NB. For plasterboard walls, specialist fixings

should be purchased from any DIY or hardware

store.

5. Fix the brackets to the wall using the screws

provided.

6. Carefully remove the small screws along the top

front edge of the cabinet to gain access to the

internal panel(s). (Fig. E) Keep screws in a safe

place.

7. Connect the cable at the rear of the cabinet to the

mains supply cable using a suitable terminal block

(not supplied) according to the wiring diagram

(Fig. 2) on the back page.

8. Hang the cabinet in position, tighten the screws

on the hangers (Fig. E) and secure the base of

the cabinet with the supplied fixing bracket and

screws (Fig.F).

9. Once fully secure, close the internal panel(s) using

the screws removed at stage 6.

10. Fit shelves in desired positions using shelf

supports.

11. Prior to re-attaching the door(s), ensure the

connector(s) are reconnected correctly. Feed

excess wire(s) back into the carcass before re-

attaching the hinges back into position.

12. If necessary, the hinges can be adjusted in order to

reposition the door(s) (Fig.G).

13. Switch the mains supply back on.

Move door(s) up/down

Move door away/towards

the cabinet

Move door(s) left/right

Door Adjustment (Fig G)

Operating Instruction

This cabinet is fitted with colour temperature

changing technology.

To switch on/off

Slowly move your hand past the sensor.

To change the colour temperature

To alter the colour temperature of the

cabinet, hold your hand underneath the

sensor, the colour temperature will start to

change.

Simply move your hand away from

the sensor when the desired colour

temperature has been reached and

continue to operate the cabinet as normal -

the chosen colour temperature will remain

even after power is switched off and on

again.

Charger socket(s) are suitable for charging

and powering electric razors, trimmers and

toothbrushes.

NB. On first use of the charger socket, inserting the

plug may prove to be stiff. Reasonable force may

be required to fully insert the plug. Make sure that

the cabinet is held firmly so that it is not pushed off

the wall. After a few uses, stiffness will ease and the

socket will function as normal.

hib.co.uk