GREAT PLANES Big Stir 40 Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Big Stir 40. GREAT PLANES Big Stir 40 20 сторінок.

❏

4. Re-drill the four holes in the fuselage to 11/64"

(4.4mm). Install four 6-32 blind nuts inside the fuselage in

the holes you drilled. Mount the landing gear to the fuselage

with four 6-32 x 3/4" (19mm) pan head screws.

❏

5. Locate the wire nose gear, plastic steering arm, two

5/32" (4mm) wheel collars, one 6-32 x 1/4" (6mm) socket

head screw and one 6-32 x 1/2" (13mm) socket head screw.

Place one of the 5/32" (4mm) wheel collars into the center

of the plastic steering arm and hold it in place with the 6-32

x 1/2" (13mm) socket head screw. Insert the 6-32 x 1/4"

(6mm) socket head screw into the remaining wheel collar.

Place the steering arm onto the wire nose wheel wire and

insert the nose gear into the holes in the landing gear

mount. The steering arm should line up with the hole in the

firewall for the steering pushrod. Place the other wheel

collar on the top of the wire. Tighten the set screws. This will

hold the wire in place.

❏

6. Locate two 5/32" (4mm) wheel collars and two 6-32 x

1/4" (6mm) set screws. Put the screws into the wheel collar.

Slide one collar onto the nose wheel axle, then your nose

wheel, and then the remaining collar. File a flat spot on the

nose gear wire where the wheel collar will be. Tighten the

set screws to hold the wheel on the center of the axle.

❏

7. Locate four 8-32 nuts and two 8-32 x 1-1/4" (32mm)

socket head cap screws. These components are the axle for

the main gear. Install the 8-32 socket head cap screw through

the wheel. Install a nut on the screw and tighten it close to the

tire but not enough to prevent it from spinning freely on the

bolt. Insert the bolt through the hole in the landing gear. Place

the remaining 8-32 nut onto the bolt and tighten it against the

landing gear. Do the same for the other axle.