GREAT PLANES Big Stir 60 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Big Stir 60. GREAT PLANES Big Stir 60 20 сторінок.

GREAT PLANES Big Stir 60 Інструкція з експлуатації
5. Position the engine on the engine mount. Adjust the
mount as needed for your engine. Position the engine 4-1/4"
(106mm) from the front of the thrust washer to the firewall.
6. Use a #36 (2.8mm) drill bit and drill the four mounting
holes for the engine into the engine mount. After the holes
have been drilled, tap them with a 6-32 tap. The Great
Planes Dead Center
Locator works really well for this task.

PROP AND SPINNER INSTALLATION

1. Install the back plate, prop and prop washer onto the
engine crankshaft. Tighten the nut to hold everything in place.
2. Screw the spinner onto the backplate.

MOUNT THE LANDING GEAR

1. Locate the aluminum landing gear. Make a line 1/2"
(13mm) from the leading and trailing edge of the center portion
of the landing gear. Make four marks 3/4" (19mm) from the
bend of the gear. Where the lines intersect is the point where
you are going to drill the hole for the mounting bolts.
(GPMR8130) Engine Mount Hole
2. Drill four 5/32" (4mm) holes in the landing gear on the
four marks you just made.
3. Locate the aluminum landing gear under the plywood
landing gear plate. Center the landing gear over the
plywood plate. Then, using the landing gear as a template,
drill a 5/32" (4mm) hole through the fuselage in each of the
four holes in the landing gear.
11