Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 Інструкція з монтажу Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Іграшка Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910. Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 10 сторінок. 1:72 metal kit
D Empennage assembly
(1) Attach a bell crank to the centre of each rudder as shown in Detail A of Figure 6
(2) Align the ribs on the two fuselage frames with the ribs on the lower horizontal
stabilizer and bond /solder them together.
(3) Align the ribs on the two fuselage frames with the ribs on the upper horizontal
stabilizer and bond /solder them together.
(4) Put the two central interplane struts between the two stabilizers and then bond
/solder them together (the forward strut includes the tail skid).
(5) Attach a rudder to the rear struts of the fuselage frame and to the central forward
strut.
E Clip the canard assembly between the forward fuselage frames.
5 AIRFRAME COVERING AND PAINTING
A If the airframe is to be painted, do it at this stage in the assembly. Paint the structure
to resemble a light to medium brown wood. If the model is to be covered with
Litespan film, do not paint those areas where adhesive will be applied.
B If the model is to be covered with Litespan film (the film), cover the flying surfaces
now. For each flying surface:
(1) Cut a piece of the film which is larger than the panel.
(2) Apply a continuous
structures where the film will be attached.
(3) Attach the edge of the piece of film to one long edge of the bay and press it down
so that it is smooth, and without creases.
(4) When the superglue has attached the film securely, apply more superglue to the
other three sides of that bay.
(5) Pull the film smooth and attach the other three sides of the panel of film, so that it
is smooth and not slack.
(6) When the film is securely attache d, use a sharp blade to trim off the excess film.
(7) Do this procedure again for all the other panels to be covered.
Figure 6
layer of cyanoacrylate adhesive (superglue) to the
RUDDERS
BELL CRANK
Detail A