GREAT PLANES ElectroStik ARF Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES ElectroStik ARF. GREAT PLANES ElectroStik ARF 20 сторінок.

❏

6. Locate the included segments of hook and loop material

and feed the ends through the slots as shown. These will

serve to hold your motor battery in place during ﬂ ight. Be

sure to overlap the ends by about 1-1/2" [38mm] underneath

the battery tray.

❏

7. Use hook and loop material or double-sided tape (not

included) to secure your receiver inside the fuselage. If you

prefer, wrap your receiver in a piece of foam rubber (not

included) and strap it into place with tie wraps (not included).

Plug the servos into your receiver along with the ESC

connector and your 6" (152.4mm) servo extension.

❏

8. Connect the aileron servo to the aileron extension and

slide the tab on the front of the wing into the slot on the fuse

as shown.

❏

9. Secure the wing by inserting the two 10-24 nylon wing

bolts into the wing and tightening them down as shown.

❏

10. Now is a good time to test the rotation of the motor

before the prop is installed. Use your radio system and motor

battery to temporarily power the motor. If the motor rotates

clockwise when viewed from the front, correct the rotation

by choosing any two of the three motor leads and reversing

their positions.

❏

11. Push the spinner backplate all the way onto the

motor shaft. The center hole may be enlarged with a prop

reamer or drill if necessary. Place the prop on the shaft so

that it is perpendicular to the screw receptacles as shown.

Finger tighten the prop nut and washer. Hold the prop shaft

and tighten the prop nut securely with a prop wrench.

❏

12. Attach the spinner cone to the backplate using the

two #4 x 1/2" [12.7mm] screws.