GREAT PLANES Firebat Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Firebat. GREAT PLANES Firebat 20 сторінок.

Install the Canopy

❏

1. Cut a 3/4" [19mm] piece from the 3/8" x 3/8" [9.5 x

9.5mm] balsa stick. Screw the metal hook into the center of

this piece. Use a drop of CA to harden the balsa. The rubber

bands and nylon screw are used to hold the canopy to

the model.

❏

2. Position the hook assembly 6-1/4" [160mm] from the

rear of the canopy. Glue it in place with 6-minute epoxy.

❏

3. Hook both rubber bands over the nylon bolt. Slide the

nylon bolt into the channel in the fuselage just aft of the aileron

servo. Make sure the bolt is above the servo wires as shown.

❏

4. Attach the other end of the rubber bands to the hook

on the canopy. The rubber bands will pull the canopy down

onto the fuselage and back onto the hatch, which will be

installed later. Note: If you installed two aileron servos, you

may need to trim the inside edge of the canopy slightly to

clear the servos.

❏

5. Remove the canopy and set it aside until later. If the

elevator control horn contacts the top of the canopy, cut the

top hole from the horn and round the corners.

❏

1. Drill a 1/16" [1.6mm] hole on the lower left side of the

fuselage 3/4" [19mm] aft of the leading edge of the wing.

❏

2. Cut a shallow channel in the wing fairing from the hole

you just made to the antenna channel molded into the

bottom of the left wing using a sharp knife.