GREAT PLANES Siren ARF Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Siren ARF. GREAT PLANES Siren ARF 20 сторінок.

IMPORTANT BUILDING NOTES

Machine screws are designated by a number, threads per

inch, and a length – for example, 4-40 x 3/4" [19mm].

This is a number four screw that is 3/4" long with forty

threads per inch.

•

When you see the term test fit in the instructions, it

means that you should first position the part on the

assembly without using any glue, then slightly modify or

custom fit the part as necessary for the best fit.

•

Whenever the term glue is written you should rely upon

your experience to decide what type of glue to use. When a

specific type of adhesive works best for that step, the

instructions will make a recommendation.

Whenever just epoxy is specified you may use either

•

30-minute (or 45-minute) epoxy or 6-minute epoxy. When

30-minute epoxy is specified it is highly recommended that

you use only 30-minute (or 45-minute) epoxy, because you

will need the working time and/or the additional strength.

•

Photos and sketches are placed before the step they

refer to. Frequently you can study photos in following steps

to get another view of the same parts.

•

The stabilizer and wing incidences and engine thrust

angles have been factory-built into this model. However, some

technically-minded modelers may wish to check these

measurements anyway. To view this information, visit the web

site at www.greatplanes.com and click on "Technical Data."

Due to manufacturing tolerances which will have little or no

effect on the way your model will fly, please expect slight

deviations between your model and the published values.

Fuse = Fuselage

Stab = Horizontal Stabilizer

Fin = Vertical Fin

LE = Leading Edge

TE = Trailing Edge

LG = Landing Gear

mm = millimeters

" = Inches