GREAT PLANES ZERO Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES ZERO. GREAT PLANES ZERO 16 сторінок. Electrifly series

❏

2. Enlarge the outer hole of a control horn using a 3/64"

[1.2mm] drill bit. Install the control horn onto the left side of

the rudder. Enlarge the inner hole (closest to the control

horn base) of another control horn using the same drill bit

and install it on the bottom of the right elevator half.

❏

3. Use your radio system to center the elevator and rudder

servos. Cut three arms from two four-arm servo horns and

install them onto the elevator and rudder servos, with the right

one pointing down and the left one pointing up. Enlarge the

outer holes of the servo horns and the rudder control horn

with a 3/64" [1.2mm] drill bit. Enlarge the inner hole of the

elevator control horn (closest to the elevator) with the same

size bit.

❏

4. Hook the remaining two 2-7/8" [73mm] pushrods onto the

elevator and rudder servo horns. Connect the 10-1/8" [257mm]

pushrods onto the inner hole of the elevator control horn and

outer hole of the rudder control horn. Slide a pushrod support

onto each 10-1/8" [257mm] pushrod. If necessary, enlarge the

holes in the pushrod supports to prevent binding. As you did

with the aileron pushrods, join the elevator and rudder

pushrods together with a 1" [25mm] piece of heat-shrink tubing

while centering the control surfaces. Apply a drop of CA to the

ends of the heat-shrink tubing.

❏

5. Position the pushrod supports in the middle of the

pushrods and lightly press them into the fuse, creating

indentations in the foam. Be sure that the pushrod support

location will not create any binding in the pushrod. Use a

sharp hobby knife to cut a hole in the foam at the

indentations you made. Insert the pushrod supports into the

holes and glue them in place.

Install the Electronics & Propeller

Note: Consult the directions that came with the ElectriFly ESC

for proper operation.

❏

1. Cut a piece of the included double-sided tape to fit your

receiver and stick it to the underside of the receiver case.

Connect the ESC, aileron, rudder, and elevator servos to the

receiver. Peel the backing from the double-sided tape and

secure the receiver to the fuse in the location shown in the

photo. Be sure that you have the servo wires positioned so

that they do not interfere with the pushrods.