HiB Photec Посібник - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник для Засоби особистої гігієни HiB Photec. HiB Photec 4 сторінки.
Друкувати сторінку
11. Once fully secure, close the internal panel(s)
using the screws removed at stage 6.
12. Fit shelves in desired positions using metal
shelf supports.
13. Reattach the door(s) ensuring the hinges
fully locate and click back into position.
14. If necessary, the hinges can be adjusted in
order to reposition the door(s) (Fig.D).
15. Switch the mains supply back on.
How to Isolate the sensor so you can
switch ON & OFF with a mains switch.
How the cabinet is wired.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
How to isolate the sensor.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
Rewire the cabinet as shown in the diagram
above. HiB recommends that all electrical
bathroom products should only be fitted by a
suitably qualified, Part P registered electrician.
For further assistance on isolating the sensor
please contact us.
Tel:
020 8441 0352
Email:
Operating Instructions
To turn illumination on or off, wave hand under
the sensor switch located at the bottom of the
cabinet.
To turn charger socket on or off, use pull cord
located next to the socket.
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) left/right
Door Adjustment (Fig D)
Lamp Replacement
Requires 2x T4 Lamps, Max 22W
CAUTION: The surface of the Lamp may
become extremely hot! Allow at least 30
minutes afterlamp failure before replacing...
1. Turn off the mains electrical supply.
2. Unscrew the two screws on top of the
chrome luminaire cap and slide translucent
cover upwards.
3. Carefully grasp the failed lamp and rotate 90°
anti-clockwise to remove the lamp from the
lamp holder.
4. Carefully push the replacement lamp into
the lamp holder and rotate 90° clockwise to
secure.
5. Slide translucent cover back into position
and reattach chrome luminaire cap.
3
hib.co.uk