GREAT PLANES S.E.5a Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Літаки GREAT PLANES S.E.5a. GREAT PLANES S.E.5a 20 сторінок.
Друкувати сторінку
PREPARATIONS
❏
1. If you have not done so already, remove the major
parts of the kit from the box (wing, fuselage, tail parts, etc.)
and inspect them for damage. If any parts are damaged or
missing, contact Product Support at the address or
telephone number on page 5.
❏
2. Separate the ailerons from the wing, the rudder from
the fin and the elevator from the stabilizer. If necessary, use
a covering iron set on medium/high to carefully tighten the
covering. Lay the control surface on a flat surface and apply
pressure over sheeted areas to thoroughly bond the
covering to the wood. Hint: Poke three or four pin holes in
the covering over the open structure in the tail surfaces. This
will allow the hot air to escape while tightening the covering.
Warning: Do not over shrink the covering or it will cause
the control surfaces to twist.
ASSEMBLE THE WING
Install the Ailerons
❏ ❏
1. Test fit the right aileron to the bottom wing with two
6.4 x 15mm hinges. If the hinges don't stay centered, stick a
pin through the middle of the hinges to hold them in position
while fitting the aileron to the wing.
❏ ❏
2. Remove any pins you may have inserted into the
hinges. Adjust the aileron so there is a very small gap
between the LE of the aileron and the wing. The gap should
be small – just enough to see light through or to slip a piece
of paper through.
❏ ❏
3. Apply three drops of thin CA to the top and bottom of
each hinge. Do not use CA accelerator. After the CA has
cured, test the hinges by pulling on the ailerons.
❏
4. Now join the other aileron to the bottom wing using the
same procedure.
❏
5. Repeat the process of installing the ailerons on the
top wing.
ASSEMBLE THE FUSELAGE
Mount the Wing
❏
1. Trim the covering from the bolt hole at the TE of the
bottom wing.
❏
2. Test fit the wing to the fuselage and bolt it into position
with a 3 x 18mm machine screw and 3mm washer.
6