GREAT PLANES MASTER CADDY Інструкція з монтажу Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вимірювальні прилади GREAT PLANES MASTER CADDY. GREAT PLANES MASTER CADDY 15 сторінок. With auxiliary power station
Друкувати сторінку
H areago
CUA
O 3. Test fit the cradle assembly to the MASTER
CADDY using the 10-24 x 1-1/4" bolt, a#10 washer and
a 10-24 wing nut. Assemble the other cradle, but glue the
small doubler on'the opposide side of the cradle since this
cradle will face the other direction when mounted on the
caddy. The foam tube cushion will not be added until
after the cradles are finished.
MOUNTING THE POWER PANEL, FUEL
PUMP AND FUEL CONTAINER
C
1. Test fit your power panel into the cutout in the
APS front.
The cutout was designed to fit, without
modification, one of the smaller power panels on the
market so you may have to cutor sand the opening larger
to fit your power panel. Once you have the opening
shaped to fit your panel, determine where the battery
leads will go and drill an appropriately sized hole in APS
upright A for the wires to pass through.
CO 2. The battery should be packed in foam rubber or
something similar to hold it so it does not slide around
inside the compartment. Foam can also be glued to the
APS sides, but donot coverup the vent holes, as airneeds
to flow through the compartment to keep flammable
gases from building up.
(
3. Plan where you are going to mount your fuel
pump and if it's an electric one, decide where the wires
should run, Itis a good idea to temporarily mount the fuel
pump and then remove it before painting your MASTER
CADDY.
O 4.
Use a modeling knife or scissors to split the
nylon strip down the middle and into two pieces 17"
long. Drill a 1/8" hole through each nylon strap about
1/2" from one end. Drill two 5/64" holes in one side of
the MASTER CADDY for the strap screws. You can