HiB 31400 Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Вентилятор HiB 31400. HiB 31400 4 сторінки. Wall mounted fans, timer/timer & humidity sensor
Також для HiB 31400: Інструкція з монтажу (2 сторінок), Інструкція з монтажу (3 сторінок)

Друкувати сторінку

Technical Information -

Hush

Power input: 220-240 V, 50 Hz

Maximum ventilation volume: 97 m

Power consumption: 7.5W

Dimensions: W158 x H158 x D107mm

Breeze

Power input: 220-240 V, 50 Hz

Maximum ventilation volume: 88 m

Power consumption: 14W

Dimensions: W152 x H152 x D126mm

Fitting

1) Choose a suitable position for your fan

according to Figure 1 on the back page. Use

a cable finder to check if there are any buried

cables or pipes in the wall or ceiling. Draw

around the outside of the fan with a pencil to

determine it's exact position.

2) Make a suitable sized hole in the wall/

ceiling with the appriopiate tools.

N.B. If wall mounted ensure the hole is

angled slightly downward to stop any

moisture running back into the motor.

If mounted in the ceiling ensure the hole is

between the joists.

3) Fit flexible ducting into the hole, flush

with both sides of the wall. Ensure the

duct slopes slightly downwards towards

the outside. Make good any plasterwork

around the duct.

4) Position the fan back into place, and mark

the four fixing points. Drill the required

holes in the marked positions. If drilling

through tile, use a ceramic drill bit. Insert

wall plugs into the drilled holes.

5) Follow a similar procedure for the outside

wall grille.

6) If ceiling mounted the ducting should be

routed to the nearest soffit.

Electrical Connection

Hush

Please ensure that the fan unit is positioned in

accordance with the diagram below i.e. With

the electrical access point (5) top left.

/hr (±5%)

Casing

Fan propeller

Function module

Protective cover of terminal block

Electrical access point

Breeze

Fascia removal

Hush

fascia and gently prise away from the casing.

Breeze

maintenance, please remove the small retaining

screw and gently prise the fascia away from the

casing.

Holes for fan mounting (x4)

Terminal block

Electrical access points

Wire fixing rack

- Depress plastic nodule on the side of the

- In order to remove the fascia for