Automated environmental systems SMS-DIALLER Налаштування та експлуатація - Сторінка 6
Переглянути онлайн або завантажити pdf Налаштування та експлуатація для Система безпеки Automated environmental systems SMS-DIALLER. Automated environmental systems SMS-DIALLER 8 сторінок. Sms alarm
Друкувати сторінкуNOTES: In order to set the Master Number, the jumper on the printed circuit board must be placed across
1. Clear All
The clear all function is done as a
precaution to ensure that there are no
settings in the system that could
interfere with your new settings.
Text:
CLEARALL
Send the message to the mobile
number in the SMS alarm panel
(this is
the number assigned to the SMS card
when it was purchased).
2. Master Number
The system requires a master number
in order to work. This number will allow
the owner to send and receive
information to and from the SMS alarm
panel.
Text:
MASTER (phone number)
Note: There must be a space between
the word MASTER and the phone
number you want to use.
Example: MASTER 07891584789
Send the message to the mobile
number in the SMS alarm panel.
Quick Guide Settings for SMS
pins 3 and 4
3. Number to Text
This is the 1st number that a text
message will be sent to in the event of
an alarm.
Text:
TEXTNUM (phone number)
Note: There must be a space between
the word TEXTNUM and the phone
number you want to use.
Example: TEXTNUM 0711365894
Send the message to the mobile
number in the SMS alarm panel.
4. Additional numbers
to text
Repeat as for step 3.
The order in which the texts are made
follows the order in which they are
input here:
Text:
TEXTNUM (phone number
Continue to repeat as for step 3. until
all the number have been input. There
is a maximum of 512 numbers that can
be entered.
5. Inputting the text message
to be sent out
This is the message that will be sent in
the event of an alarm.
Note: this will output a text for any
device that is connected to GRD and
input 1 on the PCB.
Text:
CUSTOMA (message).
There must be a space between the
word CUSTOMA and the text of the
message to be sent and there must be
a fullstop at the end.
Example:
CUSTOMA There is an
alarm in area A please attend.
A maximum of 64 characters can be
used to create the message.
If there is also a device connected to
GRD and input B then a separate
message can be set up which will show
the recipient which device has gone
into alarm
Setup as for CUSTOMA but use the
command CUSTOMB at the front
instead.
Example:
CUSTOMB There is a
flood detected in the plant room.
Repeat for inputs C and D as above.
6. Keeping the SMS card
activated
This is a requirement if a PAYG SIM
card has been purchased as inactivity
for more than 30 days will make it go to
sleep.
KA (mobile number of the
Text:
SMS unit),(number in
days)
There must be a space after the KA
and a comma between the phone
number and the number of days.
Example: KA 07895648532,28
In this example the phone number of
the SMS dialler is 07895648532 and it
will automatically send out a routine
text message every 28 days.
It is recommended to set the system up
to send a routine message at least
every 28 days.